Orion-system GPC-XP Controller Manuel d'utilisateur télécharger pdf (Page 14)

Section 4: Conﬁ guring Analog Inputs

GPC-XP Controller Technical Guide

Sensor Reading, Scaling, and Override Duration

Sensor Reading Appendix

Select from the drop down list in the <Sensor Reading Appen-

dix>

ﬁ eld (Figure 12 below) to give the sensor reading a qualiﬁ er.

For User Deﬁ ned, type in your own qualiﬁ er in the < User Deﬁ ned

Appendix>

ﬁ eld.

●

User Deﬁ ned: Enter your own in the

User Deﬁ ned Appendix ﬁ eld

●

°F: Fahrenheit

●

°C: Celsius

●

PPM: Parts Per Million

●

PSI: Pound per Square Inch

●

“WG: Inches of Water Gauge

●

Ft.: Feet

●

RPM: Revolutions per Minute

●

RH%: Humidity Percentage

●

%: Percentage

●

VDC: Volts D.C.

●

BTU: British Thermal Unit

●

CFM: Cubic Feet per Minute

●

HR: Hours

●

MIN: Minutes

●

GPM: Gallons per Minute

Sensor Scaling

Figure 12: Sensor Reading Appendix Field

Figure 13: Sensor Scaling Field

All readings are user-scalable according to the number of digits

to the right of the decimal point. See Figure 13 and values and

examples below.

●

X 1 65°F

● X 10 65.5°F

● X 100 65.54°F

● X 1000 65.543°F

Internal Schedule Used for Night Setbacks

and Overrides

If this input is reading a temperature sensor which will be using Night

Setbacks or Unoccupied Overrides, select the applicable schedule.

See Figure 14 below. Actual Schedules are set in the Schedules

Window. See instructions on page 35 for setting Schedules.

Type a value between

.1 Hours and 24 Hours

and press <ENTER>

to save.

Figure 15: Override Duration Field

Override Duration

When setting an Override Duration, you must ﬁ rst select the schedule

in the <Internal Schedule Used for Night Setbacks & Over-

rides>

ﬁ eld. When either a WattMaster Thermistor Temperature

Sensor or a Communicating Temperature Sensor is used, an Over-

ride Duration can be entered. When the Override Button is pushed

on one of these sensors during the scheduled Unoccupied Mode,

the schedule will be overridden back into the Occupied Mode. The

Override Duration determines the amount of time the schedule will

remain in Override Occupied Mode.

NOTE: If using a Thermistor Sensor, the Override can be

cancelled by pressing the override button for 3 to 10

seconds. If using a Communicating Sensor with an

Override button, pressing the button while in Override

operation will cancel the Override.

Figure 14: Schedule for Night Setbacks and

Overrides

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Orion-system GPC-XP Controller Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Orion-system GPC-XP Controller