Orion-system PT-Link II LON Manuel d'utilisateur télécharger pdf (Page 6)

PT-Link II LON

Technical Guide

PT-Link II Interface

PT-Link II Hardware Connection

You have two options for connecting the PT-Link II to your PC via

Ethernet:

1.) You may connect the PT-Link directly to your PC by using

a crossover cable (by others) as shown. See Figure 3 for

details.

2.) You can also connect both your PC and the PT-Link to an

Ethernet Hub with standard CAT5 cables. See Figure 4

for details.

Locate a CAT5 cable and plug one end into your computer’s Ethernet

port (use a crossover cable if connecting directly to the PT-Link).

If connecting directly, plug the other end of the Cable into the Ethernet

port on the PT-Link. If connecting through an Ethernet Hub, plug the

other end of the PC cable into the hub, and use a second CAT5 cable

to connect the PT-Link to the hub as well.

Power up the PT-Link by plugging in the power cable. The PT-Link

may take up to three minutes to power up completely. Once the PT-

Link is powered up, you should notice that the green “GPI05” LED

light on the ProtoCessor Board remains on continuously. See Figure

21 on page 15 for a diagram showing the location of the ProtoCessor

“GPI05” LED.

PT-Link II Ethernet Connection

Figure 4: Connecting With Ethernet Cable & Hub

Figure 3: Connecting With Crossover Cable

PT-Link LON

Connect Ethernet

Crossover Cable

To PT-Link Ethernet

Port

Ethernet Cable

Ethernet Hub

Connect Ethernet

Cable To Ethernet

Hub Port

Connect

Ethernet

Cables To

Ethernet Hub

Ports

Ethernet Cable

Computer

PT-Link LON

Connect Ethernet

Crossover Cable

To PT-Link Ethernet

Port

Ethernet Crossover Cable

Connect Ethernet

Crossover Cable Directly

To PC Ethernet Card Port

Computer

1 2 3 4 5 6 7 8 9 10 11 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Orion-system PT-Link II LON Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Orion-system PT-Link II LON